Reverse Camera for VW Touareg 2003-2017, Tiguan, Bora 2006 2007, Passat
_x000D__x000D_
Automatically display reverse image when you put the gear in the reverse
_x000D_Replace one of the original license plate lampshade, no need to drill hole
_x000D_Designed is reference to the original car style, installation is simple and beautiful, totally plug and play
_x000D_The original Sony CCD chip, clear and stable image
_x000D_With wide-angle glasses lens, wide viewing angle without dead corner
_x000D_Using a unique production process, waterproof tight durability
_x000D_Multiple circuit protection design, stable and reliable quality
_x000D_How can I install the back up camera?
_x000D_1. To run the wire to the reverse light wire, the boot panel has to come off. Remember to un clip the rear light at the bottom of the boot panel. 4 x torq screws to be removed. Here are 2, the other 2 are on the opposite site.
_x000D__x000D_
2. Then there are are then 12 clips that hold it on.
_x000D__x000D_
3. A close up on the clips
_x000D__x000D_
4. Make sure you are installing the camera on the correct side. Once you thread the rca plugs through the numberplate hole, they can come out of this hole. Note: I did this by bending a steel clothes hanger into a hook and pulling it through. I would then push the plugs past the hole and use the hook to pull the cable down and and then the plugs out one by one.
_x000D__x000D_
5. Once you have the cables out, I looked for the best place to put the receiver on the inside, added some double sided tape and stuck it in to avoid vibration. I then cable tied it to make sure it wouldn't come off in the heat. After soldering in the wires below, I cable tied everything neatly and taped up exposed wires.
The reverse light wires are:
Brown = Negative -
Black Blue = Positive +
_x000D_